Qufu Ludian Electric Power Equipment Co

Optical cable suspension clamps, pre-twisted wire suspension string manufacturers
Optical cable fittings | Optical cable fittings prices | Optical cable fittings manufacturers
Manufacturers supply optical cable fittings introduction to optical cable tension clamps, optical cable connector boxes, optical cables Down-lead clamps, suspension fittings for optical cables, installation of suspension fittings, factory direct sales. Optical cables use pre-twisted suspension clamps, which consist of inner twisted wires, outer twisted wires, suspended components and connecting hardware.
Usage: It is used as a support to hang the fiber optic composite ground wire on a linear tower or a corner tower.
Copy Copy//
Features
. The suspension clamp has a large contact area with the optical cable, the stress is evenly distributed, and there are no stress concentration points. At the same time, the rigidity of the optical cable at the hanging point is enhanced, providing better protection.
.It has good dynamic stress bearing capacity and can provide sufficient grip force (%) to protect the safe operation of optical cables under unbalanced load conditions. The outlet overhang angle (one side) can reach ~.
.The structure is equipped with flexible rubber clamps to enhance self-damping and reduce wear.
.The ends are rounded to increase the corona initiation voltage.
. The high-quality aluminum alloy material improves the mechanical properties and anti-corrosion properties of the cable clamp, and greatly extends the service life.
Ordering Instructions
.Select the appropriate suspension clamp according to the outer diameter of the optical cable and other parameters.
.The quantity is configured as a set/straight pole tower or a corner pole tower with a smaller angle.
.The twisting direction of the inner twist of the cable clamp is opposite to the twisting direction of the outer layer. The standard configuration is right-handed according to the twisting direction of the outer layer. If the twisting direction of the outer layer is left-handed, it should be noted in the order contract. .
.Select suitable connecting hardware (such as molded screws, molded hanging rings, molded hanging plates, etc.) according to the hanging points on the tower.
Optical cable fittings | Optical cable fittings prices | Optical cable fittings manufacturers Pretwisted double suspension clamps for optical cables
It consists of inner twisted wires, outer twisted wires, triangular connecting plates, suspended components and connecting fittings.
Purpose: It is used as a support to hang the optical fiber composite ground wire on the linear pole tower.
Features
.Has all the performance of a single suspension clamp.
. Use two sets of suspension components to improve the mechanical strength of the cable clamp and increase the radius of curvature, ensuring the safe and reliable operation of optical cables under the conditions of large angles, high drop, and large spans, and is suitable for large spans In special places such as rivers and high-drop valleys, the allowed line corners can be expanded to , and the exit overhang angle (one side) can reach ~.